Crystallization Kinetics of Hydroxyapatite Nano-films onStainless Steel Through a Sol-Gel Process Crystallization kinetics of nano-films of hydroxyapatite
Iranian Journal of Pharmaceutical Sciences,
Vol. 4 No. 2 (2008),
1 April 2008
,
Page 135-140
https://doi.org/10.22037/ijps.v4.41098
Abstract
This article describes the preparation and analysis of nano hydroxyapatite (HA) films on stainless steel 316Lthrough sol-gel technique. The process started with preparation of a nitrate and phosphate sol. After aging the sol for 24 h at room temperature a SS316 substrate was dip-coated and heat-treated at 350 to 450 °C fordifferent times in air. The coating phase and structure on substrate were investigated by X-ray diffraction (XRD), fourier transform infrared (FT-IR), differential thermalanalysis (DTA) and scanning electron microscopy (SEM). Degree of crystallinity and time temperature transformation (TTT) diagram of HAfilms obtained with using Avrami equation. Results indicated that HAphase began to crystallize after a heat treatment at 250 °C and the crystallinity increased at a temperature of 450 °C. The HAfilm showed a nano structure with suitable crystallinity after heat treatment.
- Crystalization
- Dip-coating
- Nano hydroxyapatite
- Sol-gel.
How to Cite
References
[2]Liu DM, Troczynski T, Tseng WJ. Water-based sol-gel synthesis of hydroxyapatite. Process Develop Biomater2001; 13: 1721-30.
[3]Hench LL, Wilson JO. An introduction to bioceramics.Vol. 1. Florida: World Scientific Publishing Company, 1993.
[4]Liu DM, Chuou HM, Wu JD. Plasma-Sprayed hydroxyapalitic coatings: Effect of diffrent calcium phosphate ceramics. J Mater Sci MaterMed1994; pp; 147-53.
[5]Brinker CJ, Scherer GW. Sol-gel science. Boston:Academic Press Inc., 1990.
[6]Mavis B, Cuneyt A. Dip coating of calcium hydroxyapatite on Ti-6Al-4VSubstrates. J Am Cer Soc2000; 83: 989-91.
[7]Sadeghian Z, Heinrich JG, Moztarzadeh F.Influence of powder pre-treatments and milling on dispersion ability of aqueous hydroxyapatite-based suspensions. Ceramics Inter 2006; 32:331-7.
[8]Liu DM, Yang Q, Troczynski T. Sol-gel hydroxyapatite coatings on stainless steel substrates. Biomaterials 2002; 23: 691-8.
[9]Ducheyne P, Raemdonck WV, Heughebaert JC ,Heughbaert M. Structural analysis of hydroxyapatite coating on titanium. Biomaterial1986; 7: 97-103.
[10]Balamurugan A, Balossier G, Kanna S, Rajeswari S. Elaboration of sol-gel derived apatite films on surgical grade stainless steel for biomedical applications. Materials Lett2006; 60; 2288-93.
[11]Weng W, Baptista JL. Sol-gel derived poroushy-droxyapatite coatings. J Mater Sci Mater Med1998; 9; 159-63.
[12]You C, Oh S, Kim S. Influences of heating condition and substrate surface roughness on the characterstics of sol-gel derived hydroxyapatite.J Sol-gel Sci & Technol2001; 21; 49-54.
[13]Porter DA, Easterling KF. Phase transforma-tions in metals and alloys. Boca Raton: CRC Press, 1980.
[14]Lopatin CM, Pizziconi VB, Alford TI. Crystal-lization kinetics of sol-gel derived hyporxapatite thin films. J Matter Sci-MatterMed2001; 12: 767.
- Abstract Viewed: 347 times
- IJPS_Volume 4_Issue 2_Pages 135-140 Downloaded: 254 times